Designing for laser cutting

From Hitchin Hackspace
Revision as of 14:12, 16 October 2021 by Mike (talk | contribs)
Jump to navigation Jump to search

Back to the Laser Cutter page

Back to the Laser Cutter Related pages

NOTE: Needs to be merged with Laser Cutting Resources

Software Guides

Laser Cutter Software

LaserCut Software Guides (deprecated)

Since the change to the new controller we are running RDWorks and Lightburn laser cutting software so Lasercut Guides are no longer particularly useful.

RDWorks Software Guides

The RDWorks original manual suffers from rather poor translation in to English. Rabbit Laser USA have taken the manual and done their best to fix the duff English. It can be found on the Rabbit Laser website

There is also a YouTube video about how to use RDWorks

Lightburn Software Guides

2D Art and Design Software

Using Inkscape

Kerf Loss and how to deal with it

When you design for laser cutting you need to account for the width of the laser beam / the width of the cut in the material. The loss of material is referred to as kerf or kerf loss. The amount of material lost can be compensated for in the laser cutting tool process by offsetting the path the laser takes to one side or the other of the artwork or design line / path. However if you are designing a box with interlinking tabs accounting for kerf loss to make sure your parts fit snugly together can get a bit tricky. One solution is to use one of the many web-based box design tools which take all the complexity away for you.

Kerf Loss Diagrams

Diagram showing how the width of the laser cut affects the dimensions of parts you design. The material loss is called Kerf Loss.
Diagram showing how the width of the laser cut can be offset to the inside from the centre of the path it would take.
Diagram showing how the width of the laser cut can be offset to the outside from the centre of the path it would take.

One of our members, Mark M, has the following to offer on accounting for kerf loss "In my experience it varies, dependent on the material batch, position on the laser bed, laser power/speed, focus setting, etc. So much that if it's critical, it needs checking on the day with the set up as similar as possible. Otherwise I assume 0.1-0.2mm for all materials."

As a Rule of Thumb assume that the laser cut removes 0.15mm.

A few examples are linked below. Alternatively you may want to make your own design and want to do the kerf compensation for your self. The following pages may help you with this..

Box Making

Laser Cutting Design and Fabrication Techniques

Minimizing Burning and Laser Associated Damage

Laser Engraving